STL-EDIT

STL-EDIT is a tool that enables the use of STL figures that have been imported into a CAD system through 3D co-ordinate measuring instruments.
It is a necessary tool forediting STL figures.

Fetures

• Key Features

Simplification

The command enables a decrease in the number of elements in order to simplify the operation, without compromising the characteristics of STL figure’s shape. There are two methods for decreasing the number of elements: one by reduction rate and the other by target number of reduction.

Noise Reduction

The command corrects a Face that has failed connection or a deformed Face that has a protrusion (referred to as ‘spike’) due to the impacts of noise during a measurement

*Deletion of Mesh Shells that Have Failed Connection

*Correction of the Protruded Vertex of Face

Smoothing

The command is capable of smoothing STL figures without impacting largely the shape of a portion rounded by executing a command for filleting.

Position Alignment

The three commands below relocate a target STL figure to a position where it overlaps an aimed element (STL figure or surface).

*Adjustment through the use of three points

*Automatic adjustment

*Manual adjustment

FillinginHoles

The 2 commands below fill up specified or all holes of STL figures.

*Filling in holes through simple operations

*Filling in holes through deformation analysis

Trim

The command trims or divides a STL figure through the use of curves and infinite planes, elements of CAD system.

Extension

The command extends an STL figure by extending the external perimeter by a specified length.

*Extension command without specifications of areas

The command extends the whole range of indicated external perimeter.

*Extension command with specification of areas

The command extends only the portion of the specified range of external perimeter

​​​​​​​

Share this